8
EN
/ Installation / Ventilation
In order to prevent accidental water ingress into
the unit below, the appliance is fi tted with a special
gasket.
1) Lay the sealing gasket out along the lower
edge of the built-in hob after cleaning the mating
surface.
2) Place the hob into the worktop cut-out.
3) To fasten the hob to the worktop, use a
screwdriver to install the four plates using the
corresponding screw in the bottom of the hob.
ROOM VENTILATION
In order to allow for correct appliance operation,
the room in which it is installed must have
continuous ventilation. The volume of the room
must be no less than 25 m³, and the quantity of
air required must be based on regular combustion
of the gas and the room ventilation. The natural
air fl ow must occur through permanent openings
in the wall of the room requiring ventilation; these
openings must lead directly outdoors, and must
have a minimum area of 100 cm².
Indirect ventilation via air taken from rooms
adjoining the one to be ventilated is also permitted,
as long as all applicable legislation is satisfi ed.
HOB FASTENING
