Bertazzoni KO30 PRO X, Инструкция по использованию и уходу

Страница: 18 / 40

Any piece of equipment works better and lasts longer
when maintained properly and kept clean. Cooking
equipment is no exception. Your Microwave must be kept
clean and maintained properly.
Disconnect the power cord before cleaning or leave the
door open to inactivate the oven during cleaning.
OVEN SURFACES
The outside surface is precoated metal and plastic. Clean the
outside with mild soap and water; rinse and dry with a soft
cloth. Do not use any type of household or abrasive cleaner.
Metal parts will be easier to maintain if wiped frequently with a
damp cloth. Avoid the use of spray and other harsh cleaners
as they may stain, streak or dull the door surface.
INTERIOR
Cleaning is easy because little heat is generated to the interior
surfaces; therefore, there is no baking and setting of spills
or spattering. To clean the interior surfaces, wipe with a soft
cloth and warm water. DO NOT USE ABRASIVE OR HARSH
CLEANERS OR SCOURING PADS. For heavier soil, use
baking soda or a mild soap; rinse thoroughly with hot water.
NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY
PART OF THE OVEN.
GLASS SURFACES
Be careful with the edge of the oven door as it is glass and
could chip or break. Wipe the window on both sides with a
damp cloth to remove any spills or spatters.
STAINLESS STEEL PARTS
The exterior should be wiped often with a soft damp cloth and
polished with a soft dry cloth to maintain its beauty. There are
also a variety of products designed especially for cleaning and
shining the stainless exterior of the oven. We recommend that
the cleaner be applied to a soft cloth and then carefully used
on the stainless exterior rather than sprayed directly on to it.
Follow package directions carefully.
CONTROL PANEL
Wipe the panel with a cloth dampened slightly with water only.
Dry with a soft cloth. Do not scrub or use any sort of chemical
cleaners. Close door and touch
STOP/CLEAR
.
CLEANING AND CARE
ODOR REMOVAL
Occasionally, a cooking odor may remain in the over the range
microwave. To remove, combine 1 cup water, grated peel and
juice of one lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100% power.
Allow to set in the over the range microwave until cool. Wipe
interior with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed for easy
cleaning. Wash them in mild, sudsy water; for stubborn stains
use a mild cleanser and non-abrasive scouring sponge. They
are also dishwasher-proof. Use upper rack of dishwasher. The
turntable motor shaft is not sealed, so excess water or spills
should be wiped up immediately.
WAVEGUIDE COVER
The waveguide cover is located on the right side wall of the
oven cavity. It is made from mica so requires special care. Keep
the waveguide cover clean to assure good oven performance.
Carefully wipe with a damp cloth any food spatters from the
surface of the cover immediately after they occur. Built-up
splashes may overheat and cause smoke or possibly catch
fire. DO NOT REMOVE THE WAVEGUIDE COVER.
GREASE FILTERS
Filters should be cleaned at least once a month. Never operate
the fan or oven without the filters in place.
1. Pull down slightly
on the tab toward
the front of the oven
and remove the filter.
Repeat for the other
filter.
2. Soak the filters in a
sink or dish pan filled
with hot water and
detergent. DO NOT
use ammonia or other
alkali; they will react
with the filter material
and darken it.
Grease filter
Tab
3. Agitate and scrub with a brush to remove embedded dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the opening.
16 17
OTX_Use & Care.indd 16 2/25/11 8:15 AM