Happy Voyager
Installing the Hoop Tech Device/Machine Set Up 23
Warning:
Any movement of the Tubular Clamping
System must only be carried out with the clamp in
the
closed position
.
Move the arm to true center (if not there already).
Press
FUNC
and arrow down to
CENTER
and press
SET
. The arm moves if it is not already centered.
Notice: The center is NOT the center of the in-
stalled hoop.
Set Up the Design:
1.
Transfer the design into Voyager
via either USB or
Compact Flash and select a design.
2. Go to the SETTING menu
by pressing
MENU
, then
using the arrow keys to select
SETTING
. Press
SET
to
enter the setting menu.
3. Make sure the design was digitized “center-center”
.
Check in window marked 3 if the Y-distances from center
and the X-distances from center are matching pairs.
If not adjust the center using the digitizing/editing software
or ignore the instructions given below.
4. Press the blue right-arrow key
in the control panel to
navigate to the third tab in the setting screen as shown
(See picture - box 4) and using the down arrow key 2 time
to access box marked 5 and select
SET.
5. Program the correct offset value for the installed
Tubular Clamping System
.
Important the values must be in the MINUS num-
bers!
MINUS — 60.3
for smaller clamping system (
ITCS1
)
MINUS — 75.5
for larger clamping system (
ITCS2
)
6. Return to the main screen
by pressing
ESC
twice.
7. Trace the design by pressing TRACE. Important:
Just in case, be prepared to hit the red panic button
during the
TRACE and any OFF-SET executions.
3
4
5
Содержание Happy Voyager
Страница 1: ...Happy Voyager Resource Manual...
