28
Attention:
Turn power switch to “O” before carrying
out any of the operations below.
Raise the needle to its highest position and
raise the presser foot lever. Attach the
presser foot holder (b) to the presser foot
bar (a). (1) Tighten the fixation screw. (A)
Attaching the presser foot:
Lower the presser foot holder (b) until the
cut-out (c) is directly above the pin (d). (2)
Lower the presser foot holder (b) and the
presser foot (f) will engage automatically.
Removing the presser foot:
Raise the presser foot.
Release the pressure foot by raising lever
(e) located at the back of the foot
holder. (3)
Attaching the seam guide:
Attach the seam guide (g) in the slot as
illustrated. Adjust the distance as required
for hems, pleats, etc....(4)
Attaching the presser foot
holder
EN
30
1. Place an empty bobbin on the spindle.
2. Guide the thread to the left, and pass it
through the bobbin winder tension.
Take the thread to the right till you
reach the bobbin.
3. Wind the thread a few times by hand
around the empty bobbin in a clockwise
direction or pass the thread through
one of the holes on the bobbin inside
out and hold the thread. Push the
bobbin to the right towards the bobbin
winding position. Press the foot control
gently. The bobbin will stop winding
when it is full. Push the bobbin to the
left to “sewing position” and remove it.
Please Note:
When the bobbin winder spindle is in
“bobbin winding” position, the machine
and the handwheel can not be operated.
To start sewing, push the bobbin winder
spindle to the left (sewing position).
Winding the bobbin
EN
