∞≤√
Yellow carton contains all hardware required for assembly:
Leveling / Ganging Modular Units
Unpack Code modules and move into the desired location.
(See DIAGRAM 1)
Level the seat front-to-back and side-to-side by adjusting
the height of the glides located on the underside of the
plinth bases, under the seating block. (See DIAGRAM 2)
Turn (rotate) the ganging bracket forks so that they are
perpendicular to the seat. (See DIAGRAM 3)
Align the units so the ganging bracket forks will fit around
the ganging bracket plates.
With a person on each side of the modular grouping, push
the units together. (See DIAGRAM 4)
See the following instructions for securing walls with
mending plate.
c o d e m o d u l a r u n i t s
Visit
Bernhardtdesign.com
for additional information.
top cover plate
mending plate
4 machine screws
Adjustable Glide
Ganging Bracket Plate
G
an
gi
ng
B
ra
ck
et
F
or
k
2
1
3
IMPORTANT NOTES
Failure to install product according to installation instructions will result in loss of warranty. Actual configuration may vary.
When moving Code modular units, lift base and move into position. Never lift unit using wall or drag unit across floor.
adjustable glides, ganging bracket fork and ganging bracket plate (pre-installed)
Adjustable Glide
View of Underside
2
4
1
