Bernal S 201-60, Инструкция по эксплуатации

Страница: 14 / 16

S 201 01-07 14
ATTENTION
SAFETY CHECK
Before termination of the start up you need to
do a safety check to see if the opener stops
and reverses correctly according to the EU
norms (EN 12453) when hitting an obstacle (max. force
= 150 N which corresponds to 15 kg, above an opening
of 50 mm). This check is necessary for security of
persons and objects. This security check and force
measurement may only be done by a professional. At
obstacle detection the door has to stop and reverse. If
the door does not run the desired path or if the door
does not reverse at obstacle detection, the force and
path programming procedure needs to be repeated. If
the force level at cut-off is either too low or too high,
you have to adjust the force accordingly via the digital
potentiometer. Then repeat the test.
If after these corrections the door still does not stop
and reverse according to the valid norms, the door
may not be operated with the garage door opener.
WARNINGS!
Please attach warnings visibly and close to the opener.
Maintenance
We recommend double check of the complete plant (door +
opener) by a professional once a year. Force cut-off, con-
nected safety devices and function of the mechanical
emergency lock need to be checked every 4 weeks. Even-
tually occurred errors must be corrected immediately by a
professional.
You can test the force cutoff by putting a piece of
wood (of min. 5 cm height) on the ground in the travel
range of the door (Fig. 27) and then close the door with
the GDO. When hitting the obstacle the door has to
stop and reverse.
Please only use max. 24V/15W (E14) light bulbs for
replacement purposes.
Batteries and light bulbs do not fall under warranty.
Dismounting and disposal
At dismounting and disposal the according local safety
and disposal regulations are to be followed.
Disconnect the operator before
opening the housing 230V ~!!!
and remove the light bulb.