Draft version 01 Operatots Manual / SmartMonitor SITE L
page 11 of 26
8
Humidity and pressure sensor
SmartMonitor SITE L has a built-in humidity and atmospheric pressure sensor which can be enabled
or disabled in the Berlinger SmartView software (version 6.0 and higher) configuration. The sensor is
located on the left side of the device.
Important:
Keep the white sensor protector clean
Do not remove the grey sensor protection
Do not press on the grey sensor protection
Do not stick any label or tape over the light sensor
The sensor shall not get in close contact with volatile chemicals such as solvents or other organic
compounds. Especially high concentration and long exposure must be avoided. Ketenes, Acetone,
Ethanol, Isopropyl Alcohol, Toluene, etc. are known to cause drift of the humidity reading.
9
Tilt / Shock / Vibration
SmartMonitor SITE L has a built-in motion sensor to record tilt, shock and vibration. The sensor is
positioned inside the device and is not visible from the outside.
Tilt, shock and vibration can be enabled or disabled in the Berlinger SmartView software (version 6.0
and higher) configuration.
No maintenance or service is required for this built sensor.
