Radio Touch
If necessary, connect other external devices (Figures 7, 8 or 9).
In stereo mode with two loudspeakers, the control panel with the station display can be
used to switch manually to mono operation.
Only use wires that are adjusted for the mains voltage method of laying.
Wires must be mounted in such a way, e.g. with cable ties, that a detached wire will not
touch another potential in the event of a fault.
Use shielded wires for interference-free signal transmission. Connect the shield to the
terminal according to the terminal labelling.
In combinations or in the immediate vicinity of electronic devices (e.g. ballasts), radio
reception can be disturbed. Before installation at the assembly location, put the radio into
operation and test it for interference. In case of interference, increase the distance to the
source of interference.
When using an antenna wire as an external antenna, make sure that the wire and the tip of
the antenna are insulated against 230 V.
Assembling the device (Figure 1)
The inserts are connected.
Insert the inserts (Figures 1, 4 and 5) correctly into the wall boxes and fasten them with the
screws provided.
Place the 2-gang frame (Figure 1, 1) over the inserts and attach the Radio Touch
application module (Figure 1, 2) and the loudspeaker centre plate (Figure 1, 3).
Carefully guide the contact pins on the radio application module into the socket
(Figure 5, 16) on the insert without bending them.
Assemble the Radio Touch and loudspeaker separately with two 1-gang frames or in
combinations.
5.2 Radio start-up
The radio is assembled.
Switch the operating voltage on.
The display shows
Enter Time/Date!
and
back
.
Press the
Enter Time/Date
! control panel.
The control panels
Automatic
,
Manual
and
Time Zone
appear.
Press
Automatic
.
The time and date are set automatically as soon as a station with RDS reception is saved
(see setting FM station with automatic search).
If no RDS signal is received,
Manual
must be selected (see Setting time and date
manually).
When using 2 loudspeakers, both loudspeakers should be activated under
Setup
,
Sound
.
When using an antenna, the external antenna must be activated under
Setup
,
FM Antenna
.
97-09894-000
Page 10/12
05/2013
