Glass sensor
If the adapter ring is to be screwed to the wall box, pry the clamp spring supports
(Figure 7, 15) out of the wall box.
This exposes the screw holes in the wall box.
Align the adapter ring (Figure 7, 14) and screw it to the wall box. The marking
TOP
on the
inside of the adapter ring must be at the top. For fastening to the wall with screws, use the
supplied set of screws and wall plugs.
The adapter ring has been fastened at the installation location.
Connect the glass sensor to the adapter being used by means of the supplied ribbon cable.
Do this by inserting the plugs into the slots provided for that purpose in the glass sensor
(Figure 2, 4) and the adapter.
The electrical connection to the adapter has been established.
Place the adapter, connecting cables and if necessary system interfaces in the wall box.
Push the glass sensor onto the adapter ring until it engages.
The engagement on the adapter ring is only a preliminary fastening. Additional fastening
using the anti-dismantling protection is necessary for operation.
Tighten the screw (Figure 7, 16) at the bottom of the adapter ring. Use a Pozidrive-type
Phillips screwdriver, size 0.
Additional anti-dismantling protection has been provided.
Connecting the glass sensor and mounting it on a 1gang flush-mounted box
The necessary adapter must be connected to a supply voltage and an interface. The flush-
mounted box is mounted at the installation location.
Screw the setscrews (Figure 6, 11) out of the sockets on the back of the glass sensor.
The head end of the setscrews has a socket for an Allen key, width 1.5 mm.
(18)
(17)
Figure 8
Remove the lower socket for the setscrew (Figure 8, 17) or if necessary make a recess in
the wall (Figure 8, 18) that can hold the socket.
Align the adapter ring (Figure 7, 14) and screw it to the wall box and the wall. The marking
TOP
on the inside of the adapter ring must be at the top. Use the supplied set of screws
and wall plugs.
The adapter ring has been fastened at the installation location.
Connect the glass sensor to the adapter being used by means of the supplied ribbon cable.
Do this by inserting the plugs into the slots provided for that purpose in the glass sensor
(Figure 2, 4) and the adapter.
The electrical connection to the adapter has been established.
Place the adapter, connecting cables and if necessary system interfaces in the wall box.
97-09440-000
Page 7/9
03/2007
