Glass sensor
Before mounting the glass sensor, peel the protective foil off of the adhesive points.
Before completing mounting, align the glass sensor and press on the areas over the
adhesive points to fix it in place.
Connecting the glass sensor and mounting it on a wall box
The necessary adapter must be connected to a supply voltage and an interface. The wall box
2gang for the glass sensor is mounted at the installation location.
x
15 mm + x
(11)
(12)
(13)
Figure 6
If necessary, measure the required surface adjustment (Figure 6, x). Screw the retaining
pins (Figure 6, 12) on the setscrews (Figure 6, 11) out by the surface adjustment x so that
they have a distance of 15 mm + x from the socket for the setscrews.
Set the surface adjustment precisely so that after mounting the glass sensor is firmly in
contact with the wall.
Connect the glass sensor to the adapter being used by means of the supplied ribbon cable.
Do this by inserting the plugs into the slots provided for that purpose in the glass sensor
(Figure 2, 4) and the adapter.
The electrical connection to the adapter has been established.
Place the adapter, connecting cables and if necessary system interfaces in the wall box.
97-09440-000
Page 5/9
03/2007
