Berkeley Varitronics Systems wolfhound pro, Руководство пользователя, Страница: 19 / 39

19
Antenna Connection
The antenna port (SMA-jack) is located just below the OLED when the unit is held in the normal
orientation (arrow (1) in Figure 3). Either one of the two antennas (Omnidirectional or Direction Finding)
will interface with this connector, as follows:
Attachment of Omnidirectional Antenna
Simply screw the antenna connector at the base of the antenna to the antenna jack on the unit (see left
side of Figure 1).
Attachment of Direction Finding (DF) Antenna
Attaching the DF antenna to the unit is done in three steps, as follows:
1) attach bracket to the DF antenna flange using the two thumb screws
2) attach the DF antenna assembly RF and Laser connectors to the Antenna and Laser jacks
respectively (see (A) left and right sides in Figure 16). Use of wrench to tighten antenna
connector may damage unit. Finger-tight only -- DO NOT use a wrench.
3) secure the Wolfhound-PRO unit to the DF antenna assembly bracket by tightening (finger-tight
only) the bracket thumb screw (see (B) in Figure 15).
Figure 16. Attaching DF Antenna Assembly Connectors to Antenna and Laser jacks on unit (A); Securing DF
Antenna Assembly Bracket to Unit with Thumb-Screw (B)