bergmann Sindre, Руководство пользователя

Страница: 8 / 12

Page 8
Pic. 27.
Pic. 30. Pic. 31.
Pic. 32. Pic. 33.
Pic. 28.
Pic. 29.
Pic. 34.
13. Adjust the VTA finally as describt in point 10, Pic. 26.
After the VTA adjustment, check all the adjustments given above, to ensure, that the setup of cartridge/tonearm
is perfectly done.
It is recomended to use a test record.
11. The adjustment pipe is a helpfull tool to ease the horizontal adjustment which is vital for a linear tracking airbearing
tonearm.
Draw the adjustment pipe onto the airpipe. Make sure the adjustment pipe is sliding frictionless on the airpipe.
Adjust the airflow if necessary, Pic. 31.
Adjust the horizontal plan as descripte above.
When the adjustment pipe, Pic. 30 sliding gently and smoothly to the left, the adjustment is correct.
12. Switch off the airsupply. Place the alignment tool on top of the platter. Ensure the alignment tool is parallel to the
airpipe, Pic. 32.
Adjust the cartridge, so the stylus tip is exactly in the groove at the alignment tool, Pic. 33. The cartridge body
must be parallel to the groove at the alignment tool, Pic. 34. Note> Operate the armlift slowly.
The azimuth is correct when the cartridge is tighten to the headshell.
Tonearm adjustment.
The tonearm can be move forward and backward on the plinth. Simply untighten the two screws holding the
tonearm, undreneath the turntable, Pic. 27. The two screws (underneath turntable), must be untighten
sufficiently to avoid scratches on the plint, when the tonearm is being moved!
Furthermore, the tonearm can be adjusted in the horizontal plan, independent of the plinth. Remove the
screw on the right topside of the the armbase, Pic. 28. A small screw, placed under this screw, can tilt the
tonearm, and adjust the horizontal plan, Pic. 29. Note> The tonearm horizontal plan will change, when the
two screws holding the tonearm (underneath turntable) is tightened afterward.
screw
adjustment pipe
Parallel
airflow adjustment valve, arm