bergmann Sindre, Руководство пользователя

Страница: 6 / 12

Page 6
5. Mount the belt around the motor pulley, Pic 9.
Hold the belt tight, and make sure the belt does not twist, Pic. 10.
Hold the belt to the left, and place the subplatter on top of the airbearing, Pic. 11.
Mount the belt around the subplatter, Pic. 12, 13 and 14.
It is important to keep the belt tight (not stretched) when you mount it.
6. Use a tool t o push down the belt carefully Pic. 15, approximately 15 mm from the subplatter upper edge.
Pic. 16.
Switch on the airsupply.
Turn the subplatter carefully by hand, at least 2 turns, to ensure the belt fall into place, Pic. 17.
4. Remove the subplatter, Pic. 6. Important> Do not cause any scratches or marks to the bearing/airbearing.
Even a small scratch can cause a noisy bearing.
Add oil to the bearing, approximately half full, Pic. 7.
Place the subplatter on top of the airbearing, and let it sink. Remove the subplatter again, Pic. 8.
If the oil is pressed out of the bearing, the amount of oil is correct. Wipe away the surplus of oil.
Be aware the oil does not flow into the airhole!
Pic. 9. Pic. 10. Pic. 11.
Pic. 17.
Pic. 12. Pic. 13. Pic. 14.
Pic. 15. Pic. 16.
Pic. 6. Pic. 7. Pic. 8.
15 mm.