USER MANUAL 1.0 | EC-COM COMMUNICATION MODULES
Berghof Automationstechnik GmbH | Harretstrasse 1 | 72800 Eningen | www.berghof.com
EC_COM_HB_en_2D1972000ZD00.docx | 2VF100205FE00.docx
16
2
1
2.6. Mounting and connecting
2.6.1. Mounting
The modules are intended for mounting rail installation (DIN EN 50022, 35 x 7.5 mm).
Push up the module against the mounting rail from below,
allowing the metal spring to snap in between mounting
rail and mounting area as illustrated.
Push the module above against the mounting wall until it
snaps in.
Rail mounting of module
To interconnect with EC1000 controller
After snapping on the EC-COM module to the rail, snap on the EC1000 module about 1cm away towards the
right of the EC-COM module. Push the second module along the rail towards the first module until you hear
the locking device snap in.
To disconnect two modules
Push down the unlock button (see figure below) of the EC1000 module that you wish to disconnect from the
EC-COM module to the left of it. Push both modules away from one another until they are about 1 cm apart.
To snap on a
single module
To take down a
single module
Push the module up and against the metal spring
located on the underside of the rail guide.
Tip the module away from the rail as shown in the
illustration.
Pull the module down and out of the mounting rail.
Uninstalling a module
Unlock botton
1
2
3
