USER MANUAL 1.1 | B-PRIMIS ET-PRIME SERIES
Berghof Automation GmbH | Arbachtalstrasse 26 | 72800 Eningen |
B-PRIMIS_ET-PRIME_EN_1.1.docx
20
4.3. Preparation for front installation ET-Prime 15
The device is intended for installation from the front into a rectangular cut-out on a panel. The
support material must be rigid and be from 1 to 3 mm thick.
Fig. 6: Dimension ET-Prime 15
Requirements:
→
To allow sufficient air circulation, it must be ensured that the device has a clear space of
at least 20 mm all round at the rear.
→
The max. ambient temperature inside the control cabinet must not exceed 55 °C in oper-
ation.
→
The support material for the installation cut-out must be flat, sufficiently stable, and be
from 1 to 3 mm thick.
NOTE
Damage to the device!
Installation on uneven support material can lead to mechanical stresses and cracks in the
front face or malfunctioning of the touch screen.
Make sure that the mounting points of the device are all in a common plane, with no
more than maximum ±0.5 mm variation.
Содержание B-Primis ET-Prime 10
Страница 1: ...USER MANUAL 1 1 B PRIMIS ET PRIME Series ...
