Translated user manual V6_EN
METO 1500XXXTS
36 / 47
9.10
Battery exchange set* (optional)
When the
METO
is equipped with a battery exchange set, change the batteries as
described:
1. Put the
METO
on a level surface, lift lever upright and emergency off-switch pushed
in.
2. Remove side panel of
METO
by unscrewing the black knob. (photo 2)
3. Disconnect the batteries by removing the plug from the socket. (photo 6)
4. Position the battery exchange cart aside the
METO.
5. Unfold the guide rails and make sure they are positioned in the cutouts. (photo 3)
6. Disengage the block pin (photo 3) and slide the batteries out of the
METO
on the cart.
7. Fold in the guide rails and position the cart so that the charged batteries are in front of
the opening.
8. Unfold the other guide rails in the same way as before. (photo 5)
9.
Reconnect the plug to the battery’s socket. (photo 6)
10. Slide the charged battery in the
METO
and secure it with the block pin. (photo 7)
11. Fold in the guide rails.
12. Switch on the
METO
and check the BATTERY STATUS screen.
13. Reassemble side panel.
14. The
METO
is now ready to use again with the fully charged batteries.
15. Charge empty batteries immediately.
Always use the high frequent trickle charger!
1. Switch off
METO
4. Remove empty batteries
7. Lock pin
2. Removed side panel
5. Put charged batteries in
8. Remove exchange cart
3. De-block pin
6. (De)-Connect plug
9. Install side panel
9
1
2
3
4
5
6
7
8
