BERG BIM-120F, Инструкция по эксплуатации

Страница: 6 / 11

EXTERNAL WATER FILTER
The external water filter must be checked regularly to ensure proper filtration and water pressure. Change cartridges every 6
months or if water pressure drops low when the ice machine is filling with water.
Problem Symptoms Solutions
Ice machine not starting up No power supply Check if unit is plugged in
Machine stops running after 3
minutes
High pressure protection Lower the ambient temperature
Ice isn’t falling into bin Ice machine is dirty
Ambient temperature is low
Clean the machine
Raise ambient temperature
Ice is too thin Water level is low
Inlet valve isn’t working
Low water pressure
Blockage in the water line
Check the water level
Make sure inlet valve is working
Check water pressure
Clear pipeline if needed
Slow ice production Condenser is dirty
Ambient temperature is too high
Not enough airflow clearance
around the unit
Clean the air filter and condenser
Lower the ambient temperature
Check to make sure there is adequate
space for airflow around the unit
TROUBLESHOOTING
ERROR CODES
Code Comments Machine action
E01
Water Curtain or Ice
Full Switch Fault
Sleeping mode and
restart after the
sliding board reset
E03 Ice Harvest Overtime Sleeping mode
E04 High Temp. Fault Sleeping mode
E05 Water Shortage Fault
Sleeping mode
E06 Over-Pressure Fault Sleeping mode
E07
Cond. Temp. Sensor
Open Circuit Fault
Keeping working
E08
Cond. Temp. Sensor
Short Circuit Fault
Keeping working
November 2020