BERG BIM-120F, Инструкция по эксплуатации

Страница: 3 / 11

WARNINGS
• This appliance is equipped with a three prong grounding type plug for your protection against shock and should be
plugged directly into a properly grounded three prong receptacle.
• Do not immerse unit, cord or plug in liquid at any time.
• Unplug cord from outlet when not in use and before cleaning.
• Do not use this unit for anything other than its intended use.
• Do not use outdoors.
• Always use on a firm, dry and level surface.
• Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or if the appliance has been damaged in any manner.
• Keep children and animals away from unit.
• Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and injury.
• All repairs should be done by authorized professionals only.
• Ensure that the designated power supply is adequate for continual usage and the voltage is correct.
*Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death.
Read the installation, operation and maintenance instructions thoroughly before installing or servicing this equipment.
UNPACKING THE UNIT
• Check to ensure the shipping carton is not damaged.
• Remove all packing material and make sure all accessories and components are included in the box.
INSTALLATION
1. The unit should be placed in a clean and flat area that has a drain. Minimum clearance for the back of the unit should be at
least 8” and 6” on each side. Clearance in front should be at least 12”. This is to allow for proper air discharge from the unit
while it’s running. If the minimal clearance on all sides is reduced, ice capacity will be reduced. For best results, do not install
next to heat producing appliances.
2. The ambient temperature where this unit is going to be installed should have a minimum of 40°F and a maximum of 100°F.
3. Check the connection, voltage and safety grounding after installation.
4. Installation should be performed by a professional technician only.
ELECTRIC CONNECTION:
1. This unit has a 115 volt NEMA 5-20P electrical connection. Please ensure proper voltage where installed.
WATER PIPE CONNECTION:
This unit comes with all of the hoses and external water filter needed for your connection.
1. Connect your main water line to the external water filter.
2. Using the hose supplied, connect it to the 3/8” FPT water inlet connection at the top of the unit and then connect to external
water filter.
3. Using other supplied hose, connect to the 5/8” FPT drain pipe connection and route that hose to the your floor drain.
4. For ice bin, attach drain hose to rear bin connection and route the hose to your floor drain.
Please note: Cube ice machines use more water than what will end up in the bin as ice. Some water will be drained out every
cycle to reduce the amount of hard water scale in the machine. This process is known as a water purge and having an effective
purge can increase the time between needed cleaning.
Minimum Maximum
Air Temperature 40°F 100°F
Water Temperature 33°F 90°F
Water Pressure 19 psi 80 psi
Do not bend the drain pipe
November 2020