Translated user manual (EN-V1)
BENOMIC S500
25 / 57
7.5
Load limiter measurement system
The
BENOMIC S500
is equipped with a load limiting system that prevents the work
platform from being used when too heavily loaded. If the load exceeds that indicated on
the safety sticker (4.3), the work platform will not go up and the indicator (11) will flash the
red alarm code 4x. Running is only possible in the low position.
The operation of the load limiting system should be checked monthly.
Put the
BENOMIC S500
on a flat concrete floor, and operate the platform upwards with
the scissor-control service button (3), as described in 8.1.1. The platform will move
upwards. Lower the platform again and put a weight of >50 kg on the platform. Then
operate the platform upwards with the scissor-control service button (3) and establish that
the platform stops rising within 50 cm, after which five short beep tones will be heard. The
load limiting system is thus approved.
It is forbidden to work with the
BENOMIC S500
if the platform does not stop as described
above!
Consult your dealer if the load limiting system does not pass this periodic inspection!
7.6
Load-holding function
If the hydraulic hose is punctured when using the work platform in the raised position, the
‘load-holding function’ will immediately operate. The work platform stops lowering, after
which the operator has to drive it back to the main path slowly. Stay calm, get help, and
contact your dealer.
7.7
Scissor-locking device
In order to be able to perform work and maintenance safely when the work platform is
raised, the scissor-locking device must always be activated.
For this, see chapter 9.2.
