Beretta 20171580, Руководство по установке

Страница: 12 / 25

2 | Installation
12
If pressure indicator is not protruding, do not continue installation
and check for leakage inside the unit.
If the fault occurs again, an accurate check of the device
components is required. Contact Technical Support
Service.
Device preparation:
1 Motor-driven deflector locking insert (model 18000 - 24000
only)
– remove the motor-driven deflector locking inserts
Assembly:
– fasten the unit to the upper part of the metallic support
– check that the unit is correctly hooked by moving it to the left
and to the right
– place the unit in the middle of the metallic support
To ease the connections:
1 Pipe locking bracket
2 Packaging polystyrene protection
– use the pipe locking bracket to space the unit lower side from
the metallic support
If there is a connection box:
– use one of the polystyrene protections from the packaging
After performing the connections:
– hook the unit lower part
– by pushing it perpendicularly toward the metallic support
2.10 Condensate discharge position
The hole for the condensate drain is provided as standard on the left
side looking back on the unit.
It is possible to move it to the right-hand side. To do so, proceed as
follows:
1 Protective cap
– remove the protection plug from the prearranged connection on
the right-hand side
1 Drainage pipe
2 Condensation discharge
– remove the drainage pipe on the left-hand side and place it on
the right-hand side
– fit the protection plug on the spare hole on the left-hand side
2.11 Refrigerating connection
The dimensions and positions of cooling connections are shown
hereunder.