Bercomac 700501-2, Руководство пользователя, Страница: 8 / 28

6
ASSEMBLY
Install the supports (item 1) on each side of the
vehicle.
Item # Description Action
1 Support
(qty 2)
Install on each
side as shown.
2 Flat washer
(qty 4)
Insert on the
bolt (item 3) as
shown.
3 Hex bolt 1/2’’ x 1’’
(qty 4 )
Insert as shown.
IMPORTANT: TORQUE ALL BOLTS ACCORDING TO TORQUE SPECIFICATION TABLE WHEN STATED:
TIGHTEN FIRMLY.
THE WINCH KIT IS TO BE USED ONLY TO LIFT BERCO ACCESSORIES, ANY OTHER USE MAY CAUSE
DAMAGE TO THE VEHICLE.
This subframe may be used to install different
attachments (see attachments page). Once installed,
it may remain permanently on your vehicle.
NOTE: It is not necessary to remove mower deck at
this step.
STEP 1
SUBFRAME INSTALLATION:
Refer to parts breakdown section for parts
identification.
TOOLS REQUIRED:
Wrenches: 5/16, 9/16, 10mm
Ratchet
Sockets: 7/16, 9/16, 3/4
Cutting pliers
Pliers
Square head screwdriver: #2
1 wrench (for the nuts on the battery posts of the
vehicle).
Install the supports
Install the female hitch (item 1)
# Item Description Action
1 Female hitch Install between the
two supports.
2 Hex bolt 3/8 x 1’’
(qty 4)
Insert as shown.
3 Flange nut 3/8’’
(qty 4)
Tighten the all the
bolts & nuts firmly.
Install the female hitch between the two supports
INSTALLING THE REFLECTORS
IMPORTANT: When operating the tractor with the
front mounted attachment, install the two red-colored
adhesive reflectors on the rear vertical surface of the
tractor’s fender.