Beper RI.163, Инструкции по применению, Страница: 7 / 36

Carbon fibre radiant panel Use instructions
EN
7
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Product description Fig. A
1. Operation knob
2. Carbon heating elements
3. Base
Base assembly
Assemble the carbon heater body and the base, using the specific fixing screws (Fig. B).
Operation
Warning! Do not cover the heater during operation
Place the heater on a horizontal surface.
Turn the knob to the left in order to pick the desired power: 450W (minimum heat), 900W (maximum heat)
Turn the knob to the right in order to turn on the swing function, setting the knob on the related powers (450W–
900W)
Turn the knob to off in order to turn off the heater
Security devices
The heater is provided with an automatic tip-over off switch, capable of turning off the heater in case of accidental
overturning.
Protection from the overheating, capable of suspending the electricity supply of the product in case of excessive
heating.
Cleaning and maintenance
Before every cleaning operation, unplug the power adaptor of the electrical outlet.
Clean the carbon heater body with a barely damp soft fabric.
Do not use chemical products for cleaning (thinners, scraping products etc.).
Do not place the heater, if it’s still hot, in its original box.
Contact the technical assistance in case of doubt and/or for any question about cleaning and maintenance.
Technical data
Power: 450-900W
Power supply: 220-240V – 50/60 Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.