Hair Dryer and Volumizer Hot Air Brush Use instructions
8
Description of product Fig.A
1. Temperature setting and operating switch
2. Ceramic coating
3. Handle
4. Cold tip
5. Swivel cord
Operation
Make sure the operating switch is placed on 0, and connect the plug to the wall socket.
Place the operating switch on the desired setting:
C – cool air shot, the appliance will blow out warm (not hot) air, and it will operate at the highest speed
1 – the appliance will operate at the lowest speed and will blow out hot air at low temperature
2 – the appliance will operate at the highest speed, and will blow out hot air at high temperature.
To switch the appliance off, place the operating switch on 0.
It is better to use the hot air brush on wet/damp hair, to reduce potential damage caused by heat.
For a faster drying and more efficient styling, part your hair in locks, and slide the brush along their entire length,
from roots to tips, without dwelling too much on the same area to avoid burns and damage to the hair.
Warning: the brush blows hot air, be careful during use not to get it too close to the scalp, to avoid
burns.
To create waves and curls, it is better to dry your hair almost completely at high temperature, and then finish your
styling at the lowest temperature (use cold air shot at the end to fix your styling).
Cleaning and maintenance
Before proceeding with any cleaning and maintenance operation, make sure the appliance is unplugged and
has completely cooled down.
After each use, it is better to clean the bristles by removing any hair or dust that might have got caught during
use.
Do not use sharp objects, to avoid damaging the ceramic coating.
Clean the handle with a slightly dampened, soft cloth; do not use abrasive or corrosive detergents.
Technical data
Power: 1100-1300W
Input: 220-240V~ 50-60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Do not put the appliance down while operating, make sure to always
switch it off before laying it down to avoid dangerous overheating.
Warning: do not use this appliance near bathtubs, showers,
basins or other vessels containing water.
