Beper P206RAF100, Инструкции по применению

Страница: 9 / 44

EN
Air cooler Use Instructions
9
Operation from control panel
Plug the air cooler into the wall socket. Display turns on, showing the room temperature; the air cooler is now in
stand-by mode.
To turn the air cooler on, press ; the air cooler activates, operating at the medium fan speed and in “Normal”
mode (relevant LED indicators on display turn on).
To turn the air cooler off, press again .
The air cooler turns on at the medium fan speed; to select fan speed, press . The LED indicator on display
shows the selected speed:
low speed
medium speed
high speed
To select operation mode, press . When the air cooler turns on, it automatically operates at “Normal” mode. It
is possible to choose the following operating modes (relevant LED indicators on the display will turn on based
on the selection).
Normal – the air cooler operates at a constant speed
Natural – the air cooler operates with the 3 different fan speeds cycling, to recreate natural breeze
Sleep – the air cooler operates with all 3 different fan speeds cycling for 30 minutes; after this time, the air
cooler operates with only high and medium fan speeds alternating, for another 30 minutes; finally, the air cooler
sets to operate at the low speed constantly, until the appliance is turned off.
To activate horizontal swing mode, press . The LED indicator on display will turn on, and the swing mode will
activate. Press the button again to turn swing mode off.
It is also possible to regulate air flow vertically, by manually adjusting the tilt angle of the front flaps.
The air cooler is fitted with an automatic turn off timer, adjustable up to 12 hours. To set the timer, press ;
display will show “00”. Press again : display will show selected time (from “01” to “12”). Each time the button
is pressed, time is increased by 1 hour. To deactivate timer, turn the appliance off by pressing , and then turn it
back on.
To activate the cooling function, press ; make sure that the water tank is not empty before activating this fun-
ction. Press the button again to deactivate.
To turn the display OFF, press .
Note: this option is only available when the air cooler is on.
Operation by remote control
The functions that can be selected and activated from the remote control are the same as those that can be
activated by control panel. Follow the same instructions above to operate the air cooler remotely.
The remote control supplied with this product contains a button cell battery (type CR2025). It is advisable to use
lithium batteries for a longer use life of the remote control.
Important: do not dispose of batteries in fire. Batteries may explode or leak.
Cleansing and maintenance
Air filter and evaporative panel
Unplug the appliance form the wall socket, and by using a screwdriver remove the panel on the back, to take out
the block composed by the air filter and the evaporative panel.
Remove the evaporative panel from the filter by gently sliding it out of its seat (it is advisable to remove the panel
by gently pushing the long side of the block towards outside).
Clean the air filter with compressed air, or using a neutral detergent and a non-abrasive sponge. Rinse thorou-
ghly under water and let the filter dry completely before re-installing on the appliance.
Clean the evaporative panel with neutral detergent and a non-abrasive brush or sponge, and rinse thoroughly
under water. Let the panel dry completely before installing back on the appliance.
Important: make sure that the evaporative panel is correctly installed and laid flat against the air
filter, to avoid leaking of water during operation.
To empty/clean the water tank, make sure that the appliance is off and disconnected from the wall socket.
Open the tank, and detach the water pump by releasing the blocks and lifting it gently until completely removed
from its seat.