Beper BP-1318, Инструкции по применению

Страница: 19 / 64

19
Arm blood pressure monitor Use Instructions
Battery Installation
Slide battery cover off as indicated by arrow. Install 4 new AAA alkaline batteries according to polarity.
Close battery cover.
System Settings
With power off, press “SET” button to activate System Settings. The Memory Group icon flashes.
1. Select Memory Group
While in the System Setting mode, you may accumulate test results into 2 different groups. This
allows multiple users to save individual test results (up to 60 memories per group.) Press “ MODE “
button to choose a group setting. Test results will
automatically store in each selected group.
2. Time /Date Setting
Press “SET” button again to set the Time/Date mode. Set the month first by adjusting the “ MODE
“ button. Press “SET “ button again to confirm current month. Continue setting the day, hour, and
minute in the same fashion. Every time the “ SET “ button is
pressed, it will lock in your selection and continue in succession (month, day, hour, minute.)
3. Saved Settings
While in any setting mode, press “ ON/OFF “ button to turn the unit off.
All information will be saved.
Note: If unit is left on and not in use for 3 minutes, it will automatically save all information and shut off.
Applying the Arm Cuff
1. Firmly insert air plug into opening located on left side of monitor unit.
2. With sticky nylon section facing outward, insert end of cuff underneath metal ring of cuff
3. Fasten cuff about 1-2cm (0.4-0.8’’) above the elbow joint. For best results apply cuff to bare arm
and keep level with heart while testing.
Note: Do not insert air plug into opening located on right side of monitor unit.
This opening is designed for an optional power supply only.