Beper 90.380, Инструкции по применению

Страница: 12 / 32

12
Induction cooker Use instructions
HOW TO CLEAN
1) Disconnect plug and wait until the unit is cooled down completely. Clean after using every time.
2) If the pots/pans are used without being cleaned, discoloration or stains may be caused.
3) Do not use benzine, thinner, scrubbing brush or polishing powder to clean the induction cooker.
4) Wipe using dish washing agent and damp cloth.
5) Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
6) Never run water over the unit (Water gets inside may cause malfunction).
TECHNICAL DATA
Power: 2000W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
Trouble code Possible reason Solution
E1 Plate surface
temperature sensor
open
Please contact the supplier
or go to a qualified service
center.
E2 IGBT
Temperature sensor
open
Please contact the supplier
or go to a qualified service
center.
E3 Abnormal supply voltage;
voltage too high.
Check power supply.
Switch on after power
supply is back to normal.
E4
Abnormal supply voltage;
voltage too low.
Please check power supply.
Switch on after power
supply is back to normal.
E5 late surface temperature sensor short-circui-
ted; empty
pot/pan heating leading
to too high temperature.
Please wait for some
minutes until the unit cools
down. Please check pot/pan.
E6 Fan failure;Air
intake/exhaust vent
blockage.
lease contact the supplier
or go to a qualified service
center. Clean the vent after
the unit cools down, then
restart.
E7 Coil panel is not
connected well; circuit
malfunction
Please contact the supplier
or go to a qualified service
center.
E8 No pot/pan on the plate.
Non-usable pans on the
plates.
Put suitable cooking
utensils on the plates.