Signalling
The control panel status is signalled by:
Ø
the LEDs on the front of the panel;
Ø
the back-lit display of 20 characters on 4 rows;
Ø
the built-in buzzer.
LEDs
ALARM
ON
: - indicates ALARM status. In the event of False Alarm - press the SI-
LENCE button to inhibit momentarily the SILENCEABLE Outputs, or the
RESET button to deactivate all the outputs definitely.
MORE ALARMS
ON
: - indicates ALARM status on more than one of the Input Points. It is
possible to view all the Points in ALARM status.
PREALARM
Blinking
: - indicates PREALARM status. When the programmed PREALARM
Delay ends, the control panel will go into ALARM status. In the event of false
alarm - press the RESET key to stop the automatic procedure.
TELECOM
ON
: -the control panel is physically connected to the telephone line.
MAIN POWER
(green)
OFF
: - indicates Mains power failure (230 V). Check for area blackout. Pro-
per functioning of the control panel will be guaranteed by the batteries until
Mains power is restored. If the area power supply is present call the instal-
ler for service!
WALK TEST
Blinking
: - indicates that at least one Software Zone is in Test status. The
outputs of the Zone in Test status will be activated for approximately one
second when the Zone goes into ALARM status. However, the Extinction
Outputs of the Zone in Test status will not be activated when the Zone
goes into ALARM status.
DISABLED
ON
: - indicates that at least one device is disabled. Use the
Disable
option
from the
MODIFYING
menu to view and change the status of disabled de-
vices.
NIGHT
ON
: - indicates NIGHT Mode functioning. The Alarm Threshold of the Input
Points will be the programmed value. If the SILENCE button is pressed du-
ring NIGHT mode - the SILENCE status will be held for the programmed
SILENCE time.
DAY
ON
: - indicates DAY Mode functioning. The programmed Alarm Threshold
of the Input Points will be increased by a set value, that is, the Input Point
will be less prone to false alarms caused by persons present in the protec-
ted ambient. If the SILENCE button is pressed during DAY Mode - the SI-
LENCE status will be held until the SILENCE button is pressed again.
FAULT
ON
: - signals at least one FAULT. The LEDs and/or the display will indica-
te the FAULT type.
6
Analogue Fire Control Panel
FireClass100
Содержание FireClass 100
Страница 1: ......
Страница 10: ...10 Analogue Fire Control Panel FireClass100...
Страница 20: ...20 Analogue Fire Control Panel FireClass100...
