Benq Color Monitor User's manual
English 4
En
gl
is
h
3. Installing the Swivel Base
1.
Place the monitor on its side. Locate the arrow and the
four slots at the bottom of the monitor.
2.
As directed by the arrow inscribed on the swivel base,
insert the four pegs on the base into the slots at the
bottom of the monitor.
3.
Push the swivel base gently toward the front of the
monitor until it is locked. Place the monitor back to its
normal position.
☞
For the supply connection of equipment over 3kg
with a rated input less than 6A an approved power
cord not below 227 IEC 53, 0.75mm
2
,
3G should be
used.
4. Installing the Monitor
This monitor is equipped with an autosensing power
supply for voltage ranges 100~240V AC, 50~60Hz.
1.
Make sure that the system power is turned off.
2.
Plug the signal cable into the video signal port of your
computer and fix it with the two screws.
3.
Connect the power cord to the monitor and attach it to
power source.
4.
Turn on the computer and the monitor.
☛
If you connect the monitor to an Apple Macintosh through a D-Sub cable, you need to buy a
Macintosh adapter to connect the video signal port of your computer and the monitor signal cable.
