Operation 45
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Menu display Time
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu
sets the length of time the OSD will remain active after your last key press. The
time length ranges from 5 to 30 seconds in 5-second increments. Use
/
to
select a suitable time frame.
•
Menu Position
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu sets
the OSD position in five locations. Use
/
to select a preferred position.
•
Language
in the
SYSTEM SETUP: Basic
menu sets your familiar language for
the OSD menus. Use
Enter
to select your language.
•
Reminder Message
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu
sets whether to display reminder messages on screen. Use
/
to select your
desired setting.
•
Splash Screen
in the
SYSTEM SETUP: Basic
menu sets a preferred logo
screen to be displayed during projector start-up. Use
/
to select a screen.
Select the lamp saver mode
• Using the remote control.
Press
SmartEco
and Highlight
Lamp Mode
and press
/
to select
Normal
/
Economic
/
SmartEco
/
LampSave
.
• Using the OSD menu.
1.
Press
MENU/EXIT
and then press
/
until the
SYSTEM SETUP:
Advanced
menu is highlighted.
2.
Press to highlight
Lamp Mode
and
press
MODE/ENTER
. The Lamp Settings
page displays.
3.
Highlight
Lamp Mode
and press
/
to select
Normal
/
Economic
/
SmartEco
/
LampSave
. The lamp brightness
vary from the different lamp mode,see the description list in table below.
If the Economic mode or SmatEco mode is selected, the light output will
be reduced and result in darker projected pictures.
Lamp Mode
Description
Normal
Provides full lamp brightness
Economic
Lowers brightness to extend the lamp life and decreases the
fan noise
SmartEco
Adjusts the lamp power automatically depending on the
content brightness level
LampSave
Adjusts the lamp power automatically and lowers the
brightness to extend the lamp life
