Operation
44
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Menu display Time
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu sets
the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
/
to select a suitable
time frame.
•
Menu Position
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu sets the
OSD position in five locations. Use
/
to select a preferred position.
•
Language
in the
SYSTEM SETUP: Basic
menu sets your familiar language for the
OSD menus. Use
Enter
to select your language.
•
Reminder Message
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu sets
whether to display reminder messages on screen. Use
/
to select your desired
setting.
•
Splash Screen
in the
SYSTEM SETUP: Basic
menu sets a preferred logo screen
to be displayed during projector start-up. Use
/
to select a screen.
Select the lamp saver mode
• Using the remote control.
Press
SmartEco
and Highlight
Lamp Mode
and press
/
to select
Normal/
Economic/SmartEco
.
• Using the OSD menu.
1.
Press
Menu/Exit
and then press
/
until the
SYSTEM SETUP: Advanced
menu is highlighted.
2.
Press
to
highlight
Lamp Mode
and press
Mode/Enter
. The Lamp Settings page
displays.
3.
Highlight
Lamp Mode
and press
/
to
select
Normal/Economic/SmartEco
.
The lamp brightness vary from the different
lamp mode,see the description list in table below.
If the Economic mode or SmatEco mode is selected, the light output will be reduced and result
in darker projected pictures.
Lamp Mode
Description
Normal
100% lamp brightness
.
Economic
Saves 20% lamp power consumption.
SmartEco
Saves up to 70% lamp power consumption depending on the content
brightness level.
