24 Operation
Switching input signal
The projector can be connected to multiple devices at the
same time. However, it can only display one full screen at a
time. When starting up, the projector automatically searches
for the available signals.
Be sure the
Advanced
menu -
Display
>
Auto Source
Search
menu is
On
if you want the projector to automatically
search for the signals.
To manually select the source:
1. Press
SOURCE
. A source selection bar appears.
2. Press
/
until your desired signal is selected and press
OK
.
Once detected, the selected source information will appear at the corner of the screen for seconds.
If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another
signal.
Controlling the projector through a Wired LAN
environment
Wired LAN allows you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other
end to the RJ45 port.
2. Make sure the menu type is
Advanced
for how to switch to the
Advanced
OSD menu.
3. Go to the
Advanced
menu -
System
>
Network Settings
menu.
4. Highlight
Wired LAN
and then press
OK
. The
Wired LAN
page is displayed.
5. Press
/
to highlight
DHCP
and press / to select
On
.
6. Press
/
to highlight
Apply
and press
OK
.
7. Go back to the
Network
page.
8. Press
/
to highlight
AMX Device Discovery
and press / to select
On
or
Off
. When
AMX Device Discovery
is
On
, the projector can be detected by AMX controller.
9. Please wait for around 15 - 20 seconds, and then re-enter the
Wired LAN
page.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector’s native
resolution. Any other resolutions will be scaled by the projector depending upon the “aspect ratio” setting,
which may cause some image distortion or loss of picture clarity. See
.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or interruption.
Source
