BENQ Corporation
12
Chapter 4. Trouble Shooting
Question 1
What should the users do when the signal icon
Cable Disconnected
appeared right after pressing the
ReScan
or
Disable Radio
button under
Peer-to-Peer (Ad-hoc)
mode?
Answer 1
Please remove the BenQ AWL200 from the MINI-PCI slot and re-insert the
device again, and then it will connect the user back on line.
Question 2
What if the user’s PC is unable to connect to the other PC right after
switching the network type from access point mode to Peer-to-Peer mode?
Answer 2
Please make sure the SSID for both PC are the same and the IP address are
in the same subnet. If both SSID and IP address are checked and the same,
but the PC is still in disconnection mode, then please remove the BenQ
AWL200 from the MINI-PCI slot and re-insert the device again to connect
back online.
Question 3
What if the user is unable to alliance with the new association after moving
from one AP service set to another under the Access Point (Infrastructure)
mode?
Answer 3
Please ensure that the SSID is the same for both APs and PC. If the SSID
is correct, then please press the
ReScan
button in the
Status
menu, and then
it should create new association for the device with the AP.
