Bennett PULSER, Руководство пользователя

Страница: 13 / 19

Bennett Pulser Assembly Instruction Manual Installation Introduction
11
HOW TO OPERATE THE P ULSER
The pulser information is carried on a ribbon cable that connects the pulser to the barrier circuit. The ribbon
cable runs through a potted conduit between the upper portion (electronics area - high voltage) section of the
dispenser to the lower portion (hydraulics area - low voltage) section of the dispenser.
The ribbon cable connects to pulser connector J2 to the first pulser in the loop. Usually this is the “A” product.
If there is more than pulser then another ribbon cable connects from the first pulser J3 (back) connector to
the next pulser J2 (front) connector and it works like this for the remaining pulsers except for the last pulser
for that side in the loop.
Note: On the last pulser, a jumper must be placed across the last set of pins on J3 to identify that pulser as the
last pulser in the loop.
P6017