Bennett 515-XP Pump Controller Instruction & Service Manual
Installation Instructions
9
SECTION 3: INSTALLATION INSTRUCTIONS
Bennett Pump Dispensers are to be installed by trained technicians. All technicians must be aware of
ALL
safety instructions. If you are
not a Bennett trained technician, please contact Bennett Technical Support at 1-800-423-6638 for training information.
Identifying the features of the unit prior to installation will provide an understanding of how to perform an accurate installation. Follow
the steps below to install a 515 Pump Controller.
515 PUMP CONTROLLER - RECOMMENDED EQUIPMENT AND MATERIALS
The items listed below are recommended for proper installation of the Bennett 515 Pump Controller.
Note:
Consult the control console
and/or point-of-sale manufacturer for component requirements.
•
P/N 140766
–
515-XP Pump Controller (1-32 Fuel Points)
•
VeriFone Adapter - P/N 105471 (included)
Note:
For use with a VeriFone interface
•
Male DB9/RJ45 serial cable (not included)
Note
: The length of the cable should be no more than 100 feet
•
(4)
–
#10 x
½”
Pan Head Phillips Thread-Forming Screws for Mounting (not included)
•
Dispenser Communication Wires - 18 AWG or larger gas and oil resistant (customer supplied)
•
Tool to remove knockouts
•
Jumpers
•
Voltmeter
•
Personal Protection Equipment
POINT-OF-SALE REQUIREMENTS
Contact the console / third party point-of-sale manufacture prior to installation to determine if any additional cables and/or connectors
are required.
The 515 Pump Controller fuel only communication ports uses a Female DB9 pin connection serial port. A Male DB9 serial cable must be
used to connect directly to the communication port using a straight through cable.
Note:
VeriFone requires VeriFone Adapter - P/N
105471 (included with the 515 Pump Controller).
IMPORTANT:
ALL POS MANUFACTURERS MUST SUPPLY AN RS-232 STANDARD DB9 (DE-9) SERIAL CABLE. THE LENGTH OF
THE CABLE SHOULD BE NO MORE THAN 100 FEET.
HOW TO REMOVE KNOCKOUTS FROM ENCLOSURE
CAUTION:
SHARP EDGES MAY BE PRESENT AFTER REMOVING KNOCKOUTS. USE CUT RESISTANT GLOVES TO PREVENT
INJURY.
Several knockouts are located around the enclosure for accessibility. Select a knockout sized to fit the desired connector, wire, cable, etc.
and carefully remove. Try not to damage the enclosure when removing knockouts. Next, insert the connector from the outside of the
enclosure.
BE CAREFUL
of sharp edges.
MALE DB9 CONNECTOR
Manufacturer Supplied Cable
