Troubleshooting
• Symptom: Actuators work reverse.
»
Wires installed backwards. Remove wires from connectors
and reverse.
»
For help with connectors visit BennettTrimTabs.com/
ConnectorHelp.
• Symptom: Actuator not working at all.
»
Check fuse
»
Check output of switch or control using a volt meter.
Connect meter leads to wire harness leads and press control
or switch.
»
Caution: Do not allow wire harness leads to touch as
control is pressed or a short circuit will occur.
»
Switch meter should show (+)12VDC or (-)12VDC. If
there is no output from the controls, the Lenco controls are
defective. Call Bennett Marine for replacement options or
visit BennettTrimTabs.com.
BennettTrimTabs.com
Need Installation Help?
We’re here to assist.
Call Bennett Marine at (954) 427-1400.
For warranty details, or general trim tab operation information, visit BennettTrimTabs.com.
