21
Note: The central part of the keypad can be removed to leave the underlying part
visible. In this case, remove the center part of the gasket and apply it to the support
after removing the central cover (Fig.2).
Otherwise, leave the cover in place, and apply the entire adhesive gasket (Fig. 3).
1.4) HOW TO REPLACE THE BATTERIES (FIG. 4)
IRI.KPAD is supplied with a 3.6V 1/2 AA battery that is not inserted, in order to preserve
battery life. To insert the battery (or replace it when it is dead), proceed as follows:
Open the container by removing the screw H, Fig.2. Screw H is a 3.5 mm TORX
security screw (fig.5), supplied with a special screwdriver. A battery removable cover
is supplied on the rear part, fixed with the two screws Y, Fig.4.
Always replace both batteries with a new batterie 3V 1/2 AA, taking care of poles.
1.5) DURATION OF THE BATTERY
The battery life always depends on the frequency of use.
The following table indicates the indicative life of batteries according to their use:
N° Activations per day* Battery life expected**
*Activations lasting about 10s
**Average temperature 25° C
100
300
7 years
3 years
2) PROGRAMMING
Before proceeding to the programming of the system, some aspects of the operating
principles must be highlighted. Before programming, carefully read all instructions.
2.1) ACCESS PASSWORD
The programming of the device is protected by an access password which should
be immediately customized.
The factory-preset password is 123456.
Take note of the new password and keep it in a safe place for future uses.
If the password is lost, the device will have to be entirely reset, and all
memorised codes will be removed.
2.2) TRANSMISSION OF THE ADMINISTRATOR PIN
Once an Administrator PIN is stored, the device behaves essentially like a normal
radio transmitter, with the difference that it is possible to insert up to 255 different
PINs and each single PIN can have different types of encoding (Rolling code ARC,
Rolling code HCS, fixed code).
3) FUNCTION MENU
After activating the keypad, and typing the access password followed by #,
access is enabled to the Function Menu (2 beeps are heard from the buzzer).
Содержание IRI.KPAD
Страница 8: ...8 5 3 1 7 9 6 4 2 8 0 ENTER LED 133 mm 29 mm 85 mm 1 50 70 Ø5 V T H ...
Страница 9: ...9 2 G ...
Страница 10: ...10 3 G ...
Страница 11: ...11 4 3V 1 2AA Y 3 5x10mm TORX 5 6 ...