Beninca BE.TOUCH, Быстрое руководство пользователя

Страница: 12 / 36

12
The Father code operates independently from
the presence of related Child codes.
In the event of not particularly complex instal-
lations, it is possible to memorise Father codes
only, as indicated in Menu 2.
A specific radio code sent to the transmitter
corresponds to each Father code. This radio
code will occupy a memory location in the
receiver.
BE.TPUCH is able to store a total of 254 codes,
which might be either Father or Child codes.
IMPORTANT: Never use codes with too sim-
ple or easily traceable number sequence.
FUNCTION MENU
After activating the keypad, and typing the
access password followed by Enter, access
is enabled to the Function Menu (2 beeps are
heard from the buzzer).
BE.TOUCH awaits that one of the 9 Menu avail-
able is selected. During this dwell time, a beep
every 0.5sec is heard:
1 Change of access password for programming
menu
2 Typing in of Father code
3 Typing in of Child code
4 Erasing of Father/Child code
5 Activation of scalar counter
6 Configuration Menu of operation
7 Configuration Menu of proximity switch
8 Check Menu of the coding type of a memo-
rised transmitter code
9 Enable Menu of ENTER button for code rep-
etition.
Press the desired menu button.
NOTE:
• The keypad is activated by laying the hand
on the front side. The keypad will switch on
after a few seconds. In this way the duration
of batteries is maintained.
• Auto shut-off is 10 seconds. After this period
of time the system must be switched on
again, as described above.
• To exit a programming menu without mak-
ing any changes, press Enter, or wait for 20
seconds (time-out time).
• A possible programming error is indicated
with a long beep, BE.TOUCH then exits the
programming phase.
MENU 1
To customize the access password
After typing key 1, the customization of the
password phase is entered, indicated by 2
beeps followed by an interval.
- Type in the new password and press EN-
TER.
- BE.TOUCH confirms the typing with 3 beeps
followed by an interval.
- Type in the new password once more and
press ENTER.
- If the two digits are the same the password
is stored in memory and the keypad returns
to stand-by mode.
MENU 2
Typing in of Father code
After typing key 2, the customization of the
Father code is entered, indicated by 2 beeps
followed by an interval. The Father code can
be composed of 1 to 9 digits.
- Type in the desired Father code and press
ENTER. 3 beeps, followed by an interval, are
heard to confirm the operation. The device is
now waiting for a command which specifies
the type of receiver coding to be used for the
code just typed in:
- Press 1 for the Rolling-code receivers
- Press 2 for the ARC receivers
- Press 3 for the Fixed-code receivers
- Press ENTER to confirm selection, BE.TOUCH
exits the programming mode.
MENU 3
Typing in of Child code
After typing key 3, the customization of the
Father code is entered, indicated by 2 beeps
followed by an interval.
The Child code can be composed of 1 to 9
digits.
- Digit the Father code (followed by ENTER) to
which the Child code should be matched (it
will be typed in after). If the typed in Father
code is not valid, an error is shown. If the
code is valid, three beeps are heard and the
device awaits that the Child code be typed
in.
- Type the Child code and then press ENTER.
The code will be matched to the Father code
typed in before. The Child code will take the
coding type and the transmitted radio code
from the Father code.