Benelli BJ750, Руководство пользователя

Страница: 23 / 51

BJ750
23
RIGHT HANDLE
1. ENGINE STOP SWITCH
When the switch is on " " position and the power is on, the engine runs.
When the switch is on " " position and the power is off, the engine will not run.
2. HAZARD SWITCH” ”
Turn to “ ” and the four direction signal lamps would flash to warn
for emergency situation;turn to " ● " for daytime driving.
3. ELECTRIC STARTER BUTTON
Pull the clutch lever or put in Neutral gear and press the button to run the
electric motor and start the engine.
4. LIGHT SWITCH
Turn switch to position of " " to light up the front lamp; Turn to " " to
light up meter lamp, city light and tail lamp; turn to "
●
" for daytime driving.
5. METER FUNCTION BUTTON
In ODO mode, turn off the key. To adjust the clock, turn on the key switch and immediately
long press the set button, when released, the hour digit will start flashing on the meter.
Short press the set button to change the number, or long-press to move the flashing digit
PRIMARY PARTS
REAR SHOCK ABSORBER
The motorcycle is equipped with one rear shock absorber.
Spring pre-load adjustment.
The rear shock absorber is equipped with adjustment ring nuts for preload
adjustment.
Adjust the spring preload as follows:
To increase the preload setting of the spring, turn the adjustment ring nut
with special wrench , to make the suspension stiffer.
Please rotate opposite direction to achieve a softer setting. After adjustment,
please make sure the lock nut tightened to ensure safety of riding.
(Preload)
Note
：
Never fill the tank so the fuel level rises into the filler neck. If the tank is overfilled, heat may cause the fuel to expand
and flow into the Evaporative Emission Control System resulting in hard starting, engine hesitation and non-compli-
ance with the emission regulation.