Benelli BJ500-6A, Руководство пользователя

Страница: 38 / 51

BJ500-6A
38
a. Place vertically the battery on a horizontal plane and remove the sealing tape.
b. Take out the electrolyte from the plastic bag. Open its cover strip and use it as filling plug for the battery.
c. Lift the electrolyte container upside down vertically and align the six filling ports of the container with the six
filling ports on the battery. Pull downward hard the electrolyte container so as to puncture the sealing tape on the
filling ports of electrolyte container. Electrolyte thus flows from the container to the battery. Check the three filling
pipes on both sides. At least there is one pipe that has bubbles coming out on each side, which means that
electrolyte filling begins normally. Attention: Please be sure not to tilt the container, or electrolyte filling may be
interrupted.
d. When you are sure that there is at least one pipe that has bubbles coming out on each side (three pipes on
each side), leave it there and keep the filling process over 20minutes.
If there is no pipe that has bubbles coming out on each side, tap slightly two to three times the bottom of the
electrolyte container and check again if there is at least one pipe that has bubbles coming out on each side (The
electrolyte cannot be taken down now).
e. When the electrolyte has completely flowed through, tap the container bottom several times to drain residual
electrolyte; and then slowly pull out the electrolyte container.
INSPECTION BEFORE DRIVING
Attention:
Please do not tear or puncture the sealing tape on the filling port.
The cover strip can be kept as filling plug for the battery.