Benefon TRACKBOX 2.1, Руководство по эксплуатации

Страница: 39 / 70

I/O SETTINGS 39
PART A: CONFIGURING SETTINGS FOR THE TRACKBOX
SETTINGS FOR ANALOQUE INPUT PINS
A c t i v a t i n g a n a l o g u e i n p u t p i n
•To activate an analogue input pin, check the Activity box
(1).
•NOTE: The input pin is NOT in use when the check box is
left blank. A signal of the pin is not detected at all.
S e t t i n g e v e n t s t a t e
Determine Event state for the analogue input pin. Event
state can be set for High , Low and Both . Click the arrow and
highlight the desired option (2).
A change in the event state causes grounding of a pin. An
event causing this could be, e.g. a sudden increase/decrease
in liquid level or a crucial change in temperature. The
Both
option means that the change in the event state is registered
for both directions: E.g. when the liquid level goes above
AND beyond allowed level.
After the change is registered, the device responds to an
event the way, it is configured in the
Event data field (see be-
low).
S e l e c t i n g e v e n t
You can determine the way, the device responds to an event.
Click the arrow on the
Event data field and highlight the de-
sired option (3).
• No action : The device does not send or log anything.
• Send status message : The device sends status message of
the event to the corresponding status message number.
• Write in event log : The device only writes down the event
in the Event log .
• Send and write : The device sends status message of the
event to the corresponding status message number and
writes down the event in the Event log .
NOTE: If the status message number is not configured (the
data field is left blank), the status message will be sent to the
service center number. For more information on configur-
ing status messages and their destination numbers, see
STA-
TUS MESSAGES FOR ANALOGUE INPUT PINS ON PAGE 40
.