Chapter 6
Transmission Function
• The meter with Bluetooth 4.0 can apply to IOS, Android 2.3.3 and above.
• The meter complies with IEC 60601-1-2 and the relevant EMC (electromagnetic
compatibility) and RF (radio transmission) requirements regulated by US Federal
Communications Commission. The purpose of these requirements is to ensure that meter
does not affect or being affected by other devices during operation.
• The meter and the transmission function may be interfered while other device is operating
nearby. Ex: mobile phone, wireless internet, etc.
• If the transmission has been interfered. Please keep the meter away from the source of
interference or turn off the interfering device.
• Please make sure the meter and the receiving device are placed within a reasonable
distance (less than five meters) during transmission via Bluetooth.
• Please do not share the meter with other people if you are using Bluetooth transmission
function. The test results from other people will also transmit to the receiving device, and
it will influence your test record.
• The Bluetooth transmission function may not work on certain types of mobile phone due to
the compatibility of Android systems.
Chapter 7
Care and Maintenance
7.1 Storing Your Meter
The meter will be affected by improper storage and handling. Please follow the instructions
and check Chapter 8 for specifications.
• Please avoid bump or other violent behavior, it may caused damage to the meter.
• Do not use this meter in a very dry environment, especially if synthetic materials are
present. It may cause damaging static discharges in a dry environment.
• Do not use the meter near the source of electromagnetic radiation, ex: electrical or
electronically equipment. It may interfere meter operation.
• Do not storage the strips in high humidity environment, or expose directly to the sunlight.
• Do not freeze or refrigerate the meter and strips.
• Keep the meter clean by wiping the exterior appearance with tissues or lin-free cloth.
• Keep your hand dry and clean while handing the strips and performing the test.
• Do not disassemble the meter for any reason.
7.2 Cleaning and Caring for Your Meter
Gently wipe the meter surface with a soft cloth slightly damp with one of the following
cleaning solutions:
• 75% alcohol.
• Super Sani-Cloth disposable wipes.
• Mild dishwashing liquid with water.
• 10% household bleach solution made in the same day. (1 part bleach with 9 part water)
Note:
• Do not allow any wet cloth or liquid to clean your meter.
• Do not allow any liquid run in or around the test port and battery cover.
• Make sure the meter is completely dry before use.
21
22
The meter provides Bluetooth transmission function. It can transmit test results to
connected device wirelessly via Bluetooth.
The screen show "bLE" means Bluetooth transmission function is working.
