BendPak HDS-14LSX, Руководство по установке и эксплуатации оборудования

Страница: 57 / 80

HDS-14LSX / HDS-14LSXE Lifts
57
P/N 5900162 — April 2018 — Rev. F3
Alignment Turn Plates
Alignment Turn Plates are used for vehicle alignments. They are used in conjunction with a Filler Plate
to fill the lowered space at the Front of the Lift.
Note : If you are going to be using your Alignment Lift for service as well as alignments, consider
purchasing additional Filler Plates. You do not want the vehicles you are servicing to be
sitting on the Alignment Turn Plates, which are more easily damaged than the Filler Plates.
The BendPak part number for the Filler Plate is 5700238; call (800) 253-2363 ,
extension 191.
To install the Alignment Turn Plates :
1. Find the required components: two Alignment Turn Plates and two Filler Plates.
2. Put one of the Alignment Turn Plates into place in the lowered space at the Front of one of the
Runways.
The Alignment Turn Plate can go in either location in the lowered space; the Filler Plate goes in the
other location.
Put the Alignment Turn Plate closer to the Front of the Lift (closer to the Tire Stops) if you are going
to be doing alignments on vehicles with shorter wheel bases; automobiles, for example.
For vehicles with longer wheel bases (bigger trucks, for example), put the Alignment Turn Plate
closer to the Rear of the Lift. This orientation prevents vehicles with longer wheel bases from
hanging so far over the Front of the Lift that they interfere with using the aligner.
Neither the Alignment Turn Plate nor the Filler Plate are bolted into place, making it easier to move
them when necessary.
3. Repeat Step 2 for the other Alignment Turn Plate and Filler Plate.