BendPak HD-14, Инструкция по установке и эксплуатации

Страница: 29 / 48

29
STEP 19
(Operation)
To Raise Lift;
1. Position vehicle tires in the center of each Runway.
2. Set parking brake and use Wheel Chocks to hold
vehicle in position.
3. Before raising vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances.
4. Raise the lift to the desired height by pressing the
push button on the power unit.
5. After vehicle is raised to the desired height, lower the
lift onto the nearest Safety Lock. Do not allow Cables to
become slack. ALWAYS INSURE ALL SAFETY LOCKS
ARE ENGAGED before entering work area.
To Lower Lift;
1. Before lowering vehicle, be sure all personnel are
clear of the lift and surrounding area. Pay careful atten-
tion to overhead clearances. Insure all tools and equip-
ment have been cleared from under the lift.
2. Raise the lift off of the Safety Locks by pressing the
push button on the Power Unit. Make sure you raise the
lift by at least two inches to allow adequate clearance for
the locks to clear.
3. Press the push button air safety valve and HOLD.
4. Push the LOWERING HANDLE on the Power Unit
until the lift has descended completely.
When lowering the lift PAY CAREFUL ATTENTION that
all personnel and objects are kept clear. ALWAYS keep
a visual line of site on the lift AT ALL TIMES. ALWAYS
make sure that all FOUR LOCKS are disengaged. If one
of the locks inadvertently locks on descent the lift and/or
vehicle may disrupt causing personal injury or death.
WEEKLY MAINTENANCE
1. Lubricate all rollers with general purpose oil or
WD-40.
2. Check all Cable connections, bolts and pins to insure
proper
mounting.
3. Lubricate Safety Lock pivot points with general
purpose oil or WD-40.
MONTHLY MAINTENANCE
1. Check Safety Locks to insure they are in good
operating
condition.
2. Check all Cables for excessive signs of wear.
3. Make a visual inspection of ALL MOVING PARTS
and check for excessive signs of wear.
4. Replace ALL FAULTY PARTS before lift is put back
into
operation.
NEVER EXCEED THE RATED CAPACITY of lift.
DO NOT USE LIFT if any component is found to be
defective or worn.
NEVER OPERATE LIFT with any person or equipment
below.
ALWAYS STAND CLEAR of lift when lowering or
raising.
ALWAYS INSURE SAFETY LOCKS ARE ENGAGED
before entering work area.
NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all four safety locks are engaged.
VISUALLY CONFIRM THAT ALL PRIMARY
SAFETY LOCKS ARE ENGAGED BEFORE
ENTERING WORK AREA.
Suspension components us on this lift are
intended to raise and lower lift only and are not
meant to be load holding devices. Remain
clear of elevated lift unless visual confirmation
is made that all Primary Safety Locks are fully
engaged and the lift is LOWERED onto the
Safety Locks, Refer to installation /operation
manual for proper safety lock procedures
and /or further instruction.
Fig 19.1