BendPak HD-14, Инструкция по установке и эксплуатации

Страница: 24 / 48

ALWAYS WEAR SAFETY GOGGLES.
4. Assemble the Washers and Nuts on the Anchors
then tap each hole with a hammer until the washer rests
against Base Plate. Be sure that if shimming is required,
enough threads are left exposed. (See Fig. 15.3)
5. If shimming is required, insert the shims as
necessary the base plate so that when the Anchor Bolts
are tightened, the Columns will be plumb. (See Fig. 15.4)
6. After any necessary shims are installed, tighten each
nut to 35-45 ft./lbs. IMPORTANT - If Anchor Bolts do not
hold when torqued to required amount, concrete must
replaced. Saw cut and remove 24” x 24” square area
each Column base then re-pour with reinforced 2500
concrete to a depth of six inches minimum, keying new
concrete under existing floor. (See Fig. 15.5)
STEP 16
(Attaching the Approach Ramp /Tire Stops)
1. Install the Approach Ramps on the entry side of
the lift. Use the Top Pin Tube for HD-14-SS-X
(See Fig. 16.1)
2. Install the Front Tire Stops at the forward side of the
lift using the M14 x 2 hex bolts, nuts and washers.
(See
Fig. 16.2)
24
Fig 15.3
Fig 15.4
Fig 15.5
Fig 16.2
Fig 16.1
WARNING!
Wheels Chock must be used on the rear wheels.
(See Fig 16.3)
Fig 16.3