BENDIX XVision, Руководство пользователя

Страница: 22 / 28

22
NOTE: Do not tamper with or adjust any
factory-installed screws while aiming the camera. Only
turn the vertical aiming adjuster.
FIGURE 39 - VERTICAL AIMING ADJUSTER
FIGURE 42 - IR CAMERA AIMED CORRECTLY
Combiner Image
Driver’s View
Horizon
Center of
Combiner
Line 200 ft. from Vehicle
200 ft. line
FIGURE 40 - IR CAMERA AIMED TOO HIGH
Combiner Image
Driver’s View
Line 200 ft. from Vehicle
Horizon
Center of
Combiner
FIGURE 41 - IR CAMERA AIMED TOO LOW
Combiner Image
Driver’s View
Horizon
Center of
Combiner
Line 200 ft. from Vehicle
200 ft. line
VERTICAL AIMING AND ADJUSTING
The virtual image should be aligned vertically so that the
horizon appears in the lower one-half to one-third of the
combiner. Keeping the image at this adjustment should
provide a view of the road when the vehicle is driven up and
down hills.
The vertical aiming adjusters can accommodate
approximately ±4 degrees of movement. If the IR camera
needs more than 4 degrees of vertical movement the IR
camera bracket will need to be adjusted. Before changing
the vertical aiming adjuster, make sure the 5/16 bolts of the
IR camera bracket are tightened to 90-100 in.-lbs.
1. Using Figures 39 - 42 and a T15 torx wrench, adjust the
angle of the IR camera as needed.
NOTE: Two turns of the vertical adjuster is equal to
one degree of IR camera movement.
NOTE: It is recommended that the IR camera
adjusters be aimed to view approximately 200 ft (61m)
in front of the vehicle. Any thermal objects closer than
200 feet will already be illuminated by the low
beam headlamps.
Vertical
Aiming
Adjuster
5/16 Bolts
Tighten to
90-100 in-lbs.