BENDIX XVision, Руководство пользователя

Страница: 19 / 28

19
22. Position the IR camera onto the factory-installed aiming
assemblies. Refer to Figure 33.
23. Rotate the pivot locks on the ends of the aiming
assemblies 1/4 turn clockwise using the included aiming
adjuster tool. This will lock the IR camera in position.
FIGURE 33 - FULLY ASSEMBLED CAMERA
24. Securely tighten the harness cable tie.
25. Ensure that the harness reaches the "A" pillar without
trouble. Once the shroud assembly is heat-shrunk, the
harness cannot be moved or adjusted.
26. After the IR camera harness is properly secured and
routed, heat-shrink the shroud assembly from the
outside of the vehicle, using a heat gun.
WARNING : Do not touch the shroud assembly after
it has been heat-shrunk. It will be hot and may
cause burns.
IMPORTANT : Be careful not to melt the wiring or
o-ring during the heat shrinking process.
FIGURE 32 - CONNECTING THE CAMERA HARNESSES
Cable Tie
6-pin connector
2-pin connector
10. From inside the cab, push the threaded nut through the
hole in the roof.
NOTE: The threaded section of the nut should protrude
past the vehicle surface. Refer to Figure 31.
11. Place the o-ring over the externally threaded end.
12. Thread the harness through the externally threaded nut.
13. Fasten the heat shrinkable shroud onto the nut.
14. Hand-tighten the shroud from the outside of the roof.
15. Torque the heat-shrinkable shroud with a spanner wrench
to approximately 15 to 20 in-lbs. or until the o-ring is
slightly flattened.
16. Route the IR camera harness to the "A" pillar of the
cab.
17. Connect the 8-pin connector of the IR camera harness
to the display harness.
18. Pull the IR camera harness through the opening between
the IR camera bracket and mounting bracket.
19. Plug the 2-pin connector of the IR camera harness into
the window heater. Refer to Figure 32.
20. Plug the 6-pin connector of the IR camera harness into
the IR camera connection. Refer to Figure 32.
21. Loosely install the harness tie-wrap around the harness.
FIGURE 31 - HEAT SHRINKABLE SHROUD ASSEMBLY
Externally
Threaded Nut
3 in.
(Approximately)
O-Ring
Heat Shrinkable Shroud