31
Tighten Rubber Boot Clip (31)
Fit the Pads (see Section 6.2)
Attach the Brake Chamber or Spring Brake (see
Section 12.2 or 12.4)
M+P-KN-042
39
31
31
31
10.2.2 Caliper with Steelcap (10a)
It may be easier to remove the Caliper and the
Carrier from the axle to replace the Steel Cap.
IMPORTANT!
Replace the Rubber
Boot (10) by the Steel Cap (10a) when
replacing the Sleeve (5), the
O-Ring (31a) and the Screw (40)
at the same time. Replace only on the
recommendation of the Axle or Vehicle
manufacturer. On SB 6... (19.5“) only
permissible after manufacturing date
A0026. (see type plate).
Assembly at the Vehicle :
The fitting must be carried out with the Pads installed.
- Clean the area.
- Using the Grease supplied (II14525), lightly lubricate
the O-Ring and place it over the cast spigot (see
Sketch).
- Remove the Threated Pins from the assembly tool (G)
to avoid damaging the Steel Cap.
- Hold the new Steel Cap on the end of the Spigot.
By using a suitable press or special assembly tool
(Part Number Z001105) and a hammer, press the
Steel Cap fully on the spigot making sure not to
deform the Cap.
After removal, the Steel Cap and the O-Ring must
not be refitted.
IMPORTANT!
The Steel Cap (10a) and the O-Ring
are single use items - do not re-use.
FD00108
31a
10a
10
31
40
5
2mm
FD00106
X
X
V
