200780_1
PLACEMENT
This heater is designed to be placed on a hard, level surface. When positioning, please keep the
following points in mind:
•
If you are placing the heater in an alcove, make sure that there is at least 50mm of space on either side
and at the rear of the heater to ensure good air circulation.
•
The heater must not be located over a fixed electrical socket. The socket must always be accessible in
order to disconnect the heater from the electrical supply for maintenance.
•
Keep hearth rugs and other soft furnishings away from the front of the heater. They could obstruct the
free flow of hot air from the fan and damage both soft furnishings and heater.
CONTROLS
Never cover the heater or obstruct the opening at the base of the heater, this could cause
overheating and consequently risk of fire.
OPERATION INSTRUCTIONS
The following switches are located on the back of heater.
•
Insert plug into mains socket
•
Select the desired functions:
•
Switch 1 (I / O) - Switches On / Off electricity supply to the heater and flame effect
•
Note:
This switch must be in the ON (I) position for heater to operate
•
Switch 2 (I) - Switches On / Off 1000W heat output
•
Switch 3 (II) - Switches On / Off 2000W heat output
•
Note:
The flame effect can be operated with or without the heat
•
Rotate thermostat knob (4) clockwise or anti-clockwise to increase or decrease desired room
temperature setting.
•
NOTE:
The heater will only work if O / I switch (1) is ON and thermostat (4) is set above current
room temperature.
SAFETY CUT-OFF
This appliance is fitted with a safety cut-off which will operate if the heater overheats (e.g. Due to
blocked air vents). For safety reasons, the heater will NOT automatically reset. To reset the appliance,
disconnect the appliance from the mains supply for at least 15 minutes check air vents for blockages,
reconnect the supply to the mains and switch on the appliance.
1 2 3
4
