Security
WUFA_vers02.doc
12 of 29
2
Chapter
To identify the power tool, the housing
must not be drilled.
The protective insulation will be broken.
Use adhesive labels.
Do not use the power tool with a
damaged cable. Do not touch the
damaged cable and pull the mains plug,
if the cable is damaged while working.
Damaged cables increase the risk of
electric shock.
Before each use, check the power tool
for wear out. The electric tool must be
able to be completely closed via the
lever and the seaming rollers must be
securely mounted.
If the power tool falls, check if it is
damaged.
After you have checked the power tool,
keep yourself and other persons stand-
ing near away from it and allow the ma-
chine to run at maximum speed for a
minute
.
Only adhesive labels may be used to
mark the machine.
The machine must not be drilled in for this
purpose
.
Regularly clean the ventilation slots of
the machine. The motor fan draws dust
into the housing and excessive accu-
mulation of powdered metal may cause
electrical hazards. Do not use the ma-
chine near flammable materials. Sparks
can ignite these materials
Use the two handles on the machine
when inserting it onto the standing
seam profile.
Make sure that the working area is
always sufficiently illuminated. Never
work without lighting or at twilight.
If the machine gets jammed, turn off it
immediately
2.4 Residual risks
Although this operating manual contains
detailed information on safe working with
the machine, it contains certain residual
risks, which cannot be completely exclud-
ed by safety measures. Therefore, always
operate the machine with the necessary
caution!