28
8.1.5 UTC1100(SD) Command Set
1.
Brightness <04> <n>
Brightness level (n = level).
n = <20>, 20%
n = <40>, 40%
n = <60>, 60%
n = <FF>, 100%
2.
Back Spacing <08>
Move cursor position to the left one position, erasing the character, if any, that was in
that position.
3.
Horizontal Tab <09>
Horizontal tab.
4.
Line Feed <0A>
Line feed.
5.
Carriage Return <0D>
Move cursor to the first position of the current line.
6.
Display Position <10> <n>
Move the cursor to any position on the display. “n” is the digit position where the cursor
is to be moved to.
7.
Normal Display Mode <11>
After writing a character, the cursor is shifted automatically to the right one position.
8.
Vertical Scroll Mode <12>
After writing the characters up to the last position of the second row, all characters
displayed in the second row are shifted to the upper row (first row), clearing the second
row. Default mode.
9.
Pass-Through Mode <1B> <64>
This command is used in Direct to pole mode to begin passing data through to the
attached device.
10.
Reset Display <1F>
The display will be cleared and reset to the default of <DC2> mode (Vertical Scroll).
The cursor will be positioned to the first position on the top line.
11.
Flashing Text Start <1C>
Start blinking text.
12.
Flashing Text End <1D>
Stop blinking text.